Comtech EF Data CSAT-6070 - Manual (Page 23)

CSAT-6070
C-Band Transceiver
50 and 100 Watt
Transmit
Frequency, RF 6725 to 7025 MHz
6725 to 7025 MHz (Optional Extended)
6725 to 7025 MHz (Optional Wide)
6725 to 7025 MHz (Optional Super
Wide)
Frequency IF 70 MHz ± 18 MHz
140 MHz ± 36 MHz (Optional)
Output Power, P
1Db
(50W) +47 dBm
(100W) +50 dBm
Gain (50W) 74 dB
(100W) 77 dB
Attenuator Range 25 dB in 0.25 dB steps
Gain Flatness ± 0.75 dB full RF band
± 0.75 dB per 36 MHz
Gain Stability ± 0.25 dB at constant C
± 1.00dB from -40° to+55°C (-40 to
131° F)
Carrier Mute
-70 dBc
Intermodulation -33 dBc for two carriers at 6 dB OPBO from
rated power
Second Harmonic -55 dBc
Spurious AC line harmonics -45 dBc
Carrier related, <500kHz -60 dBc
All other in-band (50 W) -18 dBm -65 dBc
(100 W) -15 dBm -65 dBc
AM to PM Conversion 3.0° at 6 dB OPBO from rated power
RF Output VSWR 1.25:1
RF Output Connector CPR137G
IF Input Impedance 50 Ohms
IF Input VSWR 1.25:1
IF Input Connector Type N Female
Receive
Frequency RF 4500 to 4800 MHz
Frequency IF 70 MHz ±18 MHz
140 MHz ± 36 MHz (Optional)
Gain, without LNA 45 dB
Gain Flatness, without LNA ± 0.75 dB full RF band
± 0.75 dB per 36 MHz
Gain Stability, w/o LNA ± 0.25 dB constant temp.
± 1.00 dB -40° to +55°C
Output Power, P1dB +13dBm
Two Tone Inter-modulation -50 dBc for two tones at 0 dBm each, 1 MHz
apart
Image Rejection -60 dBc
RF Input VSWR 1.25:1
RF Input Connector Type N Female
IF Output Impedance 50 Ohms
IF Output VSWR 1.25:1
IF Output Connector Type N Female
Common
Conversion Dual, no spectral inversion
Frequency Step Size 1.0 and 2.5 MHz automatic
Frequency Stability 1x10 -9 /day
1x10 -7 /year
-40° to +55°C 1x10 -8 /Temp
Attenuation Tx 0-25 dB in 0.25 dB
steps
Rx 0-20 dB in 0.25 dB
steps
Phase Noise
100 Hz -66 dBc/Hz
1 kHz -76 dBc/Hz
10 kHz -86 dBc/Hz
100 kHz -96 dBc/Hz
Group Delay Linear 0.1 ns/MHz
Parabolic 0.02 ns/MHz 2
Ripple 1 ns p-p
Monitor and Control
Methods Both EIA-485 and EIA-232 Serial
Interface
Handheld
controller, optional
Commands Set Tx frequency
Set Rx frequency
Set Tx attenuation
Set Rx attenuation
Report Tx output power
Mute Tx
Report internal temperature
Report power supply voltages
Set time
Set date
Faults Upconverter functions
Downconverter functions
Upconverter Synthesizers
Downconverter Synthesizers
Internal Reference oscillator
LNA current fault
Over temperature condition
Environmental
Temperature -40° to +55° C (-40 to 122° F) Operating
-50° to +75° C (-90 to 135° F) Storage
Altitude 15,000 ft, mean sea level
Humidity 0 to 100 Percent, Relative
Prime Power 90 to 260 VAC Standard
47 to 63 Hz Standard
48 VDC Optional
Dimensions: 50 W 9.75H x 10W x 23D inch
(24.77H x 25.4W x 58.42D cm)
100 W 10 H x 12.5W x 26D inch
(25.4H x 31.75W x 66.04D cm)
Weight: 50 W 65 lbs (29 kg)
100 W 80 lbs (40 kg)
Low Noise Amplifier 45° K, non-isolated
2 11 4 Wes t 7t h St. Tem pe , A Z 8 5 2 8 1 U S A
Tel. ( 4 8 0 ) 33 3 - 2 2 0 0 . F a x ( 4 8 0 ) 3 33 - 2 5 4 0
e m a i l : s a l e s @ c o m t ec h e f d a ta . c o m
w w w. c o m t e c h e f d a ta. c o m
Comtech EF Data reserves the right to make changes to specifications of products described in this
data sheet at any time without notice and without obligation to notify any person of such changes.
© 2001 Comtech EFData (Part Number DS/CHP1.DOC) 12/21/01