Comtech EF Data CSAT-6070 - Manual (Page 7)

s:\tpubs\manuals\released_word\transceivers\csat6070-50w\errata\mn-c607050-ec0.doc 1
Errata C
Comtech EF Data Documentation Update
Subject: Changes to Section 2.6.2.1, Assemble Waveguide Switch
Date: September 15, 2003
Original Document
Part Number/Rev: MN/CSAT607050.IOM Rev 0
Errata
Part Number: MN/C607050.EC0
This information will be incorporated into the next revision.
Change Specifics:
2.6.2.1 A SSEMBLE W AVEGUIDE S WITCH , AS/0462
Refer to Figure 2-19.
Figure 2-19.
Assemble Waveguide Switch, AS/0462
1. Refer to Table 2-12, Figure 2-16
and Figure 2-19
2. Remove all protective tape from
switch and keep it clean.
3. Install waveguide termination (1)
and gasket (3) to Port 2 of switch
(7) and secure with bolts (6),
lockwashers (5), and flat washer (4).
4. Install waveguides (2) and gaskets (3) to Ports 1 and 3 of switch (7) and secure with bolts (6),
lockwashers (5), and flat washers (4).
5. Finished assembly should look identical to Fig 2-19
6. Set waveguide switch assembly aside for later installation.
Port 4
Port 3
Port 2
Port 1