Comtech EF Data CSAT-6070 - Manual (Page 50)

50 Watt Model C-Band Transceiver Revision 0
Installation MN/CSAT607050.IOM
15. Tighten nut to secure the tension strap.
16. Slide two springnuts, (5, figure 2-2) into channel of the unistrut bracket
(1, figure 2-1).
17. Repeat procedure for second unistruct bracket (1).
18. Install bracket (1, figure 2-10) and secure to the unistruts with four bolts, lock
washers ( ), and flat washers ( ).
19. Ensure that the bracket is centered on the unistruts. Tighten hardware.
IMPORTANT
When installed, ensure the CSAT 50 Watt unit fan is facing outward
20. Install brackets (1, figure 2-2) and secure to
unistruct brackets with four bolts (6), flat
washers (2) and split lock washers (3).
21. Position brackets (1) against center bracket.
Do not tighten hardware at this time.
22. Install four bolts ( , figure 2- ) with split
washers ( ) , and flat washers ( ) into
provided mounting holes in the CSAT 50
Watt casting.
23. Carefully lift the unit, and slide the bolt head into the groove of bracket
(1, figure ).
24. Ensure the washers are between the unit and the bracket. Do not tighten
hardware at this time.
25. Temporary install the assembled waveguide switch (Figure 2-19).
26. Ensure that the ports line-up and can be secured. If a gap is present, adjust by
sliding the unit and bracket (1, figure 2-2) on the unistrut (In or Out).
27. Tighten hardware.
2-26