Digital Alert Systems DASDEC-II QUICK START UP GUIDE - Manual (Page 15)

Quick Start Guide for Your DASDEC II
Page 15 of 40
3) With the antenna lines connected to the DASDEC-II adjust the internal tuners for your
assigned monitors. Use the radio buttons (circled in red) to set the band to FM, AM or
NOAA. When FM or AM band is selected enter the desired frequency in the field circled in
green, then click “Accept Typed Frequency Change”. When “NOAA Weather Radio” is
selected (as in the lower half of the picture below) click on the desired NOAA frequency.
4) After setting the tuning on the radios verify they are receiving audio. Each tuner can be
listened to, one at a time, from any of the options you see on the screen by the “Listen On:”
heading.
5) After verifying audio reception you must now set the DASDEC-II’s Decoder. Click on the
“Setup” tab (circled in red), then click on the “Audio” radio button (circled in green) and finally
the “Decoder Audio” tab (circled in blue).