Digital Alert Systems DASDEC-II QUICK START UP GUIDE - Manual (Page 34)

Quick Start Guide for Your DASDEC II
Page 34 of 40
12) On the Alert Encoding Audio Configuration page you must click on the check box (circled
in red) for each audio output you’ll be using. “Main Audio Output” is on the terminal block on
the back of the DASDEC-II, depending upon your hardware configuration “Aux 1 Audio” and
“Aux 2 Audio” are on the 1/8
th
inch audio jacks on the back.
13) If you are using the “Main Audio” input as an EAS Audio Loop through the final step in the
Station Interface configuration is to enable this feature. Click on the “Audio Output” tab
(circled in red).
14) Scroll down the page to the Main Audio heading and check the box for “Main Audio
Passthrough”