Digital Alert Systems DASDEC-II QUICK START UP GUIDE - Manual (Page 29)

Quick Start Guide for Your DASDEC II
Page 29 of 40
6) Finally, the section Configure Available FIPS for Encoder Alert Origination is where you
assign which counties your DASDEC-II will originate alerts for; refer to your state’s EAS plan
to determine which counties you may need to add to this list. Note – Any county for any
individual station which will use this DASDEC-II needs to be added to the Available
Encoder FIPS Locations on the right, counties can be removed from individual station
interfaces later.
7) Your DASDEC-II’s Encoder is now configured.