DNF Controls 2034CL-L-PBIO VS.3.0 - Manual (Page 23)

23 2034CL-L, Vs.3.0, 300 Clip Instant Access System, Louth Protocol, PBIO
Option
21. FUNCTION TABLE
Function Key Press Description
GOTO
ENTERED TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time.
Use the ST300 numeric keypad. Press [ENTER] or [RECUE].
NOTE: Use 00:00:00:00 to recue a clip to ET=0 if start time is
not ET=0
GANG [SHIFT] + [VTR #1]
OR
[SHIFT] + [VTR #2]
OR
[SHIFT] + [VTR #3]
Individually press the VTR keys to be included in the gang. The
LED above the key will turn on. Press the VTR key again to
remove from gang, the LED above the key will turn off. Press
[ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by RECORD MODE
in the SETUP MENU. Press [RECORD] OR [RECORD] +
[PLAY].
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the Wheel (or move
the T-Bar, if available) to change the play speed.
Press [SLOMO] to STILL frame.
OR Press any transport key to exit SLOMO.
SLO-MO SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to preset the
slo-mo speed. Turn the Wheel to select desired speed.
Press [ESC] or any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME MODE
SELECT [TIME MODE] Press to toggle between ET (Elapsed Time) and
RT (Running Time) display modes.