DNF Controls 2034CL-L-PBIO VS.3.0 - Manual (Page 26)

26 2034CL-L, Vs.3.0, 300 Clip Instant Access System, Louth Protocol, PBIO
Option
23. TROUBLESHOOTING
a. ST420 TROUBLESHOOTING
1)
All keys are RED - no communication with ST300.
2)
All keys are dark - no communication between the ST300 and the Video Server.
3)
The version of the ST420 must comply in the software version with the ST300 it
is connected to.
To determine the software version of the ST420 do the following:
a)
Press [SHIFT] + [STOP] + [PLAY].
The key that displays the current version is RED.
b) The ST420 displays:
“SELECT ST300 V2.1 or V2.0 or V3.0.”
Press the key for the software version of the ST300 you are using.
Please refer to the ST300 to determine the version if needed.
b. VERSION 3.0 HARDWARE OF ST300 ONLY
VIDEO REFERENCE SETUP
Plug the video reference BNC cable into the BNC connector on the back of the ST300.
Plug the same video reference into the SYNC IN connector on the rear of the Video
Server.
Press [MENU].
1)
Turn the Wheel until the display says “SYNC.”
2)
Press the Softkeys to toggle between SYNC ON and OFF. (Default = ON)
Installing sync into the ST300 and the Video Server, and selecting Sync ON will
help assure that several channels in the gang will roll in sync.
(For example, Fill and Key.)