Installing optional controls – Desa (V)CB36N(E) User Manual

Page 12

Advertising
background image

www.desatech.com

117437-01B

1

6. Use clips to mount receiver on remote mount-

ing bracket as shown in Figure 16.

INSTALLING OPTIONAL

CONTROLS

Continued

9-Volt
Battery

Battery
Housing

Battery
Cover

Terminal
Wires

Remote
Control
Unit

Towards Front

REMOTE ON OFF

Figure 16 - Mounting Remote Receiver to

Bracket

Figure 17 - Installing Battery in Hand-

Held Control Unit (HRC100 Series)

Figure 18 - Installing WRC Remote Receiver

Figure 19 - Installing Battery into Back of

Handset

Fireplace
Receptacle

Remote
Control
Receiver

Extension Cord

Ignition
Module
Plug

Pull to
Remove
Insulation
Tab

Battery Cover

1 Volt Battery

Back of Handset

Plastic Mounting
Clips

Remote Receiver

Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit

1. Remove battery cover on back of remote

control unit.

2. Attach terminal wires to a 9-volt alkaline bat-

tery (not included). Place battery into battery

housing (see Figure 17).

3. Replace battery cover onto remote control unit.

INSTALLING OPTIONAL WIRELESS
REMOTE CONTROL - MODEL WRC
(Electronic Ignition)

Installing and Activating the Remote
Receiver

1. Open bottom louver and locate plug recep-

tacle. The plug receptacle is located either on

the right or left side of cabinet.

2. The WRC model receiver does not require

a battery. Receiver can be installed by first

plugging short extension cord into fireplace

receptacle. Then plug receiver unit into exten-

sion cord. Finally plug ignition module plug

into receiver unit (see Figure 18).

3. Activate remote handset battery by removing

insulating tab on back of handset (see Figure

19). Battery is included preinstalled.

4. Once battery is activated unit is ready to use.

5. Replace bottom louver panel.

Advertising