Desa (V)CB36N(E) - Manual (Page 18)

www.desatech.com 117437-01B 18
INSTALLING LOGS AND GLOWING
EMBERS
A 4 piece ceramic log set comes packed inside the
unit firebox. Removal of glass door is necessary
to unpack and assemble logs and add hearth treat-
ments. Follow steps under Removing/Replacing
Glass Door, page 17 to access logs and burner.
Assemble logs and add burner treatments as
follows:
1. Position base log onto burner log mounts (see
Figure 31).
Note: Cut out on bottom should fit over
mounts and base log should be positioned
against rear panel.
2. Position holes on bottom of rear log over pins
on base log (see Figure 31).
3. Position top left log and top right log onto rear
log and base log as shown in Figure 31.
Figure 31 - Installing Logs
FIREPLACE INSTALLATION
Continued
Figure 32 - Applying Ember Material
4. Break ember material into quarter sized pieces
and place a single layer along the full length
of ember tray to hide bottom edge of base log.
(see Figure 32).
5. Replace glass door and louver panels (see
Removing/Replacing Glass Door, page 17).
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Top
Right
Log
Top Left
Log
Rear
Log
Burner
Base Log
Rear Log
Stand
Burner
Pan
Log
Mounts
Ember
Tray
Ember
Material