Desa (V)CB36N(E) - Manual (Page 21)

www.desatech.com 117437-01B 1
OPERATING FIREPLACE
Continued
OF
F PIL
O
T
LO
IH
ON OFF REMOTE
ON
OFF
O
N
Blower Control Knob
(Optional Accessory)
Variable
Control Knob
Selector Switch in
Remote Position
Gas Control Knob
in ON Position
Figure 36 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
34). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 20.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 36). Note:
The burner may light if hand-held remote was
on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Figure 37 - On/Off Hand-Held Remote
Control Unit HRC100
Control
Button
Indicator
Light
ON/OFF SERIES MODEL HRC100
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 37).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
OPTIONAL GWMS2
ON/OFF WALL
MOUNTED SWITCH
WARNING: Do not connect
the appliance gas controls to a
120 VAC power source. Damage
or injury may occur.
Light the fireplace as instructed in Lighting
Instructions on page 20 . If using an HRC re-
mote with a wall switch, set the remote selector
switch to the ON position (see Figure 36). The
wall switch may now be used to turn the burner
flame ON and OFF.
To turn the fireplace off, turn the wall switch
and/or remote selector switch to the OFF posi-
tion and turn the gas control knob back to
PILOT. The pilot will remain lit.
IMPORTANT:
To turn the pilot off, turn the
gas control knob on the heater to the OFF
position.