Fluke Biomedical ProSim 4 - Manual (Page 22)

ProSim™ 4
Users Manual
12
The breaths per minute (brpm), heart rate (bpm), invasive and non-invasive
blood pressure simulation parameters are shown at the top of the display. To set
the breath rate, touch one of the pre-defined respiration rates shown in the
display.
To change which ECG lead the respiration simulation will be on, touch the
softkey in the lower-left corner of the display.
The softkey text will change to the one value not set. For example, when Left
Arm Lead is shown in the softkey, the respiration simulation will be on the left leg
ECG lead.
Touch the Home softkey to go back to the Home screen.
Non-Invasive Blood Pressure Simulation and Tests
The Product simulates blood pressure for non-invasive blood pressure monitors.
Each blood pressure variable can be set through the display controls. The
Product also does leak and pressure relief tests.
How to Set the Non-Invasive Blood Pressure Parameters
To do a non-invasive blood pressure simulation, connect the Product to a blood
pressure cuff and monitor as shown in Figure 6.
ProSim 4
Patient
Monitor
Mandrel
Dual hose system: connect Cuff Adapter to
hose marked “Sense”. If both hoses are
unmarked, connect Cuff Adapter to either
hose.
Blood Pressure Cuff
Wraps around mandrel.
Must be connected closer
to the cuff than monitor.
gne020.eps
Figure 6. Non-Invasive Blood Pressure Test Connections