Fronius Selectiva 8 kW User Manual
Page 14
12
The machine is tested to "Degree of protection IP20", meaning:
-
protection against penetration by solid foreign bodies with diameters exceeding 12.5
mm (0.49 in.)
-
no protection against water
The device can be set up and operated in dry, closed areas that comply with degree of pro-
tection IP20. Exposure to wet conditions should be avoided.
The air surrounding the charger must be kept free from battery acid vapour as far as pos-
sible. You should therefore avoid setting up the charger directly above the battery being
charged.
Cooling air
The charger must be set up in such a way that the cooling air can flow unimpeded through
the vents in the housing that are provided for that purpose. Ensure that there is always a
minimum of 0.2 m (7.874 in.) of space around the air inlets and outlets. The surrounding
air must be free from
-
excessive dust content
-
electrically conductive particles (carbon black or swarf)
-
heat sources
Cooling air is drawn in and flows out as indicated by the arrows in the following illustrations.
If the chargers are arranged in a line one behind the other without being offset, the space
between the chargers must be as follows:
-
Selectiva 8 kW: Minimum distance 30 cm (11.81 in.)
-
Selectiva 16 kW: Minimum distance 60 cm (1 ft. 11.62 in.)
Wall bracket
NOTE! Air inlets and outlets must never be covered, not even partially. If several
chargers are set up one behind the other, they should be offset.
16 kW: 60 cm (1 ft. 11.62 in.)
8 kW: 30 cm (11.81 in.)
WARNING! Work that is carried out incorrectly and falling chargers can cause se-
rious injury and damage. This installation must only be carried out by trained and
qualified personnel. Take note of the safety rules in the charger operating instruc-
tions.
Different wall plugs and screws will be required depending on the supporting sur-
face. Wall plugs and screws are therefore not included in the scope of supply. The
installer is responsible for selecting the right wall plugs and screws.