Fronius Selectiva 8 kW - Manual (Page 34)

32
When a relay board has been selected, one of the following functions can be set for each
of the 4 terminals (-> 1) to (-> 4), viewed from left to right:
-
Aquamatic
-
Signal to activate a solenoid valve, for example
- "Standard" program with preconfigured factory settings
- "User" with user-defined settings
- More information about Aquamatic can be found under "Aquamatic" in the "Op-
tions" section.
- Charging
- Charge 80%
- Charge end
- Main Charge Finished
-
Signal to indicate that the main charging phase has finished
- Charge OK
-
Battery is being charged or is already fully charged
- Common error:
-
Signal in the event of an error
- A power failure can also be displayed as an error if required (setting "ON")
- Freely-defined text, which could for example include the contact details of the
dealer, can be displayed if the device is in an error state. More information can be
found in the "USB mode" section.
- Signal Lamp:
-
One or more suitable lamps can be connected to the relay board to indicate the
state of charge or operating status of the charger.
- More information can be found under "Signal lamp" in the "Options" section.
- Immobiliser device
- ON:
-
The relay picks up permanently as soon as the charger is connected to the mains.
- Refill Indicator:
-
Signals that the battery needs topping up with distilled water.
- More information can be found under "Additional functions" in the "Display" sec-
tion.
- Battery Cold
- "External Air Pump" for electrolyte circulation
-
The settings are applied as described under "-> Settings" for the air pump
More information on the relay board can be found in the "Options" section.
External lamp setting:
as described under "Charging Lights" in the "Options" section, suitable signal lamps can
be connected to indicate the state of charge or operating status of the charger. The follow-
ing settings are available:
-
normal (conventional signal lamps)
- RGB (LED strips)
The contrast for the remote control system can be adjusted.
At mains failure restart charging:
If this option is chosen, the charging process is restarted automatically as soon as the
mains supply becomes available again after a disruption to the electrical mains supply.
Remote control system: