Fronius Selectiva 8 kW - Manual (Page 22)

20
Display
Overview of
modes The device has the following modes:
As long as a battery is connected to the battery charging system, the charging process can
only be interrupted and resumed using the "Stop/Start" key. Display modes can be
changed using the "Menu" key as described in the following sections that explain the indi-
vidual modes, but this is only possible when there is no battery connected to the battery
charging system.
Standard mode Once the mains plug has been connected to the public grid, the display will automatically
operate in standard mode.
In standard mode the display shows the
charging parameters:
-
Type of battery (e.g. wet)
- Charging characteristic (e.g. IUI)
- Battery voltage (e.g. 48 V)
- Capacity (e.g. 300 Ah)
- Day of the week, date and time
The charging parameters can be set individually. More information can be found in the
"Configuration mode" section.
Menu selection Change from standard mode to the menu
selection as follows:
Standard mode
In standard mode the display shows the charging parameters
Statistics mode
Visualises the frequency of the device operating modes and shows the total
number of charging actions. Also shows an overview of the total and average Ah
produced and energy consumed per charge
History mode
Provides information about the parameters for all the stored charging processes
Configuration mode
Configuration mode enables all the settings for the device and the charging pro-
cess to be adjusted
USB mode
USB mode enables a device to be updated, device configurations to be saved
and loaded, and the charging parameters to be recorded during the charging
process - all using a USB stick
Press and hold the "Menu"
key for approx. 5 seconds
1