GAI-Tronics ITA2000A ITA2000A Series Tone Remote Adapter with Scanning User and Installation Manual - Manual (Page 20)

Installation ITA2000A Series Tone Remote Adapter
03/13 16
Conventional to Scanning Operation Conversion
N OTE : The ITA2000A includes an LED labeled MON
(top) and
SCAN
(bottom). It is the third LED
from the left when looking at the unit from the front. In Conventional mode, the LED indicates monitor
operation. In Scan mode, the LED will flash at the scan rate and illuminates steadily when the adapter
locks onto a channel (monitor).
Locate SW1-7 on the unit’s front panel, and place it in the down position.
The unit will perform a reboot and begin operation in the Scan mode. When the unit is powered up or
when exiting diagnostics, the hybrid balance tone will be heard twice. This will not cause any harm to
the system.
N OTE : The scan or scanning features of the radio must not be programmed or selected. The ITA2000A
will not function properly if the radio is programmed with scan functions.