Terminal strip designations, Field installed options, Model spk200 solar interface kit – GAI-Tronics 13363 Addressable Amplified Speakers Installation and Operation Manual User Manual
Page 53: Model xb001 external long-life battery enclosure
Pub. 43004-034F
Model 13353, 13363, and 13373 Addressable Amplified Speakers
Page 48 of 52
e:\radio products-current release\43004\43004-034f\43004-034f.doc
03/15
Terminal Strip Designations
The wiring terminal strip, TB101, is located on the rear section of the speaker assembly. The screw
terminal designations for all models are as shown below. Refer also to Figure 9.
Terminal Strip
Label
Function
15
VDC
POWER
+
External power source (positive)
15
VDC
POWER
−
Ground reference
AUDIO
IN
600
L1
Positive audio input
AUDIO
IN
600
L2
Negative audio input
PAGE
CTRL
L1
Active low signal to activate speaker assembly
PAGE
CTRL
L2
Ground reference
AUDIO
OUT
600
L1
Positive audio output
AUDIO
OUT
600
L2
Negative audio output
OUTPUT
CTRL
+
Output control to the Model 530-001 Strobe or control relay
OUTPUT
CTRL
−
Ground reference
Field Installed Options
Model SPK200 Solar Interface Kit
The Model SPK200 Solar Interface Kit provides battery recharging when an external power source is not
available. This option is supplied with a terminal block, battery charge regulator module, solar mounting
bracket, wiring harness, and the necessary mounting hardware for the components. This option provides
a complete solar charging system when purchased with the GAI-Tronics Model RFP7784-108 Solar
Panel. Refer to Pub. 43003-039 for solar panel installation details. This kit must be used in conjunction
with the XB001 External Long-Life Battery Enclosure and the 40201-008 18 Ah battery.
Model XB001 External Long-Life Battery Enclosure
The Model XB001 External Long-Life Battery Enclosure includes a NEMA 4 weatherproof enclosure
with battery mounting bracket, a sealed 15 V dc external receptacle, and mating speaker power
connection cable. The required Model 40201-008 18 Ah battery is purchased separately.
This assembly allows the Addressable Amplified Speaker to be installed within two feet of the
weatherproof enclosure for true battery-powered operation. Combining this kit with the Model SPK200
Solar Panel Interface Kit and Model RFP7784-108 Solar Panel can provide a completely wireless
operation (if RF operation is used). If the application is only temporary, the speaker can easily be
“unplugged” from the battery enclosure and relocated or stored. Refer to Pub. 43003-037 for installation
details.