Gasboy Enhanced Communications - Manual (Page 20)

Site Preparation, Setup Programming, and Testing
Page 20 MDE-4520C Enhanced Communications Installation Manual · February 2008
Site Preparation, Setup Programming, and Testing
Assembling the Connector (M06547B001)
Parts Required
The following parts are required to assemble a N-plug connector:
• Nut
• Washer
• Gasket
• Clamp
• Male contact
• Plug body
Note: You will need a soldering iron to assemble the connectors.
Figure 12: N-plug Connector Parts
To assemble the N-plug connector, proceed as follows:
1 Place the nut, washer and gasket (with the “V” groove towards the open end of the cable) over
the cable, and cut off the jacket to dimension a.
a = 0.359” (9.1 mm)
c = 0.234” (5.9 mm)
2 Comb out the braid and fold out. Bare the center conductor to dimension c as shown.