Gasboy Islander PLUS - Manual (Page 64)

3-5. CONNECTIONS TO ISLANDER PLUS
All connections to the Islander PLUS must be performed to the Terminal Block located at the
bottom of the Islander PLUS pedestal (see Figure 3-5, Figure 3-6). The required connections are:
1. Dispenser wiring connections:
• Pulser (Low Voltage)
• In Use signal (High voltage)
• Valve (High voltage)
2. Communications
• RS-232/LAN to TLG Controller to Gas Tank
• RS-485 for Orpak peripheral device
• Pump communication line (e.g. Current Loop, RS485, Tokheim, RS422)
3. Mains AC Power and Ground
4. LAN connection
Islander PLUS Manual 50