Ivoclar Vivadent UTS 3D - Manual (Page 11)

11
5.4 3D-registration joint
The 3D-bite fork (8.0) is attached to the 3D-bite fork
connection (7.5) by means of the 3D-bite fork connector
screw (7.4).
The bite fork (older version) can be attached to the
connector (7.3), as the connector is equipped with the
corresponding adapter on the opposite side. For this
purpose, the connector screw (7.4) has to be changed to
the opposite side.
The 3D-registration joint (7.0) is secured on the multi-
functional mounting (1.6) with the registration joint
connection screw (1.11).
The tommy screw (7.2) secures the 3D-registration joint.
5.5 Adjusting the width
The width of the transferbow can be adjusted by
loosening the 'width setting' screw. If the minimum width
is not sufficient, the black earpieces 'L' (9.0) can be used.
In this way, an additional 20 mm of space is available.
5.6 Additional height in the area of the
nosepiece
If the nosepiece rod (2.2) is rotated by 180°, an
additional 10 mm is gained.
1.11
7.0
1.6
2.2
2.2
7.3
7.4
7.5
7.1
7.2 8.1
8
7.3
7.4
7.5
7.1
7.2 8.1
8
1.7
5.0
7.3 7.5
UTS 3D-BA-WE1.qxd 07.04.2005 15:27 Uhr Seite 11