Q-See QSTC201 - Manual (Page 36)

QSTC201/211 IP-CAMERA USER MANUAL
36
5.4.7 Alarm out
1. Enter into “Alarm configuration"— "Alarm output" refer to Figure 5-13:
2. Select the alarm out number, alarm holding time and alarm name on the
"Alarm out”, “Alarm holding time” and “Name” pull down list respectively.
3. Press the "Save" button to save the settings.
Fig 5-13 alarm configuration—alarm out
Please refer to the following table for parameters and instructions of alarm out.
Parameter Meaning
Alarm out The alarm equipment which is connected to the device
Alarm holding time After triggered the holding time of the alarm output
Name The name (number) of the alarm
5.5 Network configuration
Network configuration includes four submenus: basic configuration, IP
configuration, wireless configuration and DDNS configuration.
5.5.1 Basic configuration
1. Enter into "Network configuration"--"Basic configuration", refer to Figure 5-14:
2. Input port number for IE access in the "HTTP Port" textbox.
3. Input the port number for audio & video transmission in the "Data Port"
textbox.
Fig 5-14 network configuration-- basic configuration interface