Q-See QSTC201 - Manual (Page 9)

QSTC201/211 IP-CAMERA USER MANUAL
9
User can connect the PC (Surveillance Center) and IP-CAMERA as shown in the
above picture. Before connecting to PC, user needs to connect external devices,
and then connect the power. Connecting sensors or alarm boxes is optional and
depends on user’s needs.
The connection steps are shown below:
Step 1: Transfer line 1 connects to alarm box and IP-CAMERA first, and then
connect to alarm devices. (For more details please refer to IP-CAMERA
hardware installation 2.2).
Step 2: Transfer line 2 connects to MIC and Headphones
Step 3: Internet line connects to Internet broadband modem or router.
Step 4: Connect power cable to a power outlet
2.2 IP-CAM hardware installation
This section describes how to connect camera stand and alarm devices
(optional).
1. 1. 1. 1. Install IP-CAMERA
Step 1: Turn one end of the extension stand to the screw hole on the groove of
the base
Step 2: Turn the other end of the extension stand clockwise on the screw hole of
the IP-CAMERA and adjust it as shown in Fig 2-2
Fig 2-2 Install IP-CAM
Step 3: Adjust the IP-CAMERA and the stand to the desired position
2. 2. 2. 2. Connect to alarm devices as shown as Fig 2-3