Q-See QSTC201 - Manual (Page 64)

QSTC201/211 IP-CAMERA USER MANUAL
64
6. Q ： ： ： ：How can I set this IP Camera up on a wireless router?
A: 1. Connect camera to the Router using the network cable provided
2. Make sure the PC is connected to the same Router
3. Check the IP address of the Router by running IPCONFIG from the PC ( go to command
prompt and type in ipconfig). Note the ip address. As an example here the IP is 192.168.1.100
4. Install the CMS program.
5. Run IP TOOL. Default login is system and password is 123456
6. This tool will detect the IP camera automatically and show the IP address of the camera. By
default the IP address of Camera is 192.168.0.201. Based on the example above, the IP of the
Network is 192.168.1.100. So in this case we need to change the IP of the camera to 192.168.1.201.
To do this, right click on it and choose Network setup and change the IP address and change the
gateway to 192.168.1.1
7. Open Internet Explorer, enter the camera IP which is 192.168.1.201 on the address bar.
8. You will get the login screen and just enter 123456 for password.
9. To setup the wireless, click on System Config on the bottom right. Then click on Wireless
config from the menu on the left side.
10. Check the Wireless Switch
11. Click on Refresh. It should detect all the Routers within range. Select your router.
12. On the SSID it should come up with all Router’s information, and if your Router is encrypted,
you have to put your Key, and leave the option to use the following IP defaulted to 192.168.1.201.
Click on Save.
13. Now you can unplug the network cable and then you can move the camera to wherever
you want as long its still within the range of the wireless router.
14. Within the same network you should be able to login to this camera using the same IP of
192.168.1.201