Marantz M-CR502 - Manual (Page 11)

7
NAMES AND FUNCTIONS
BASIC CONNEC-
TIONS
BASIC
OPERA
TIONS
BASIC
SETTINGS
PRACTICAL
CONNECTIONS
ADV
ANCED
OPERA
TIONS
IF YOU EXPERIENCE
PROBLEMS
MISCELLANEOUS
BASIC
CONNECTIONS
ENGLISH
BASIC CONNECTIONS
CONNECTING SPEAKERS
Notes:
• Always be sure to use speakers having the
impedance specifications listed on the unit’s rear
panel.
• To prevent damage to the circuit, do not allow
speaker wires to come in contact with each other
or with metallic parts of the unit.
CONNECTING SPEAKER CABLES
1. 2.
3. 4. 5.
1.
Strip approximately 10 mm of insulation
from the ends of the speaker cables.
2.
Tightly twist the exposed strands of speaker
wire in order to prevent shorting.
3.
Turn the speaker terminal counterclockwise
to loosen the terminal.
4. Insert the exposed part of the speaker cable
into the hole on the side of the speaker
terminal.
5.
Turn the speaker terminal clockwise to
tighten the terminal.
CONNECTING A SUBWOOFER
Be sure to use the audio output terminal for a sub-
woofer on the unit when connecting to a powered
sub-woofer (a sub-woofer with built-in powered
amp).
For details on making connections, see the
instruction manual for your sub-woofer.
• Do not touch speaker terminals when the power is
ON as there is a risk of electric shock.
• Do not connect more than one speaker cable to
one speaker terminal as there is risk of damage to
the unit.
• Make certain that the polarity is correct when
connecting to the speaker terminals. If the
polarity is incorrect, the signal phase will become
inverted and the music being played will sound
unnatural.
SETTING SPEAKER OUTPUTS
After turning on the unit’s power (See page 11), set
the speaker output for the unit to match the speaker
connections made to terminals A and B.
The default setting is SPKR A.
Note:
Be sure to lower the audio volume before making
speaker settings.
1.
2.
1.
2.
1. Press the SPKR A or SPKR B button to
match speaker connections made to A and
B terminals.
Note:
Once the SPKR A or B button on the remote
controller is pressed, the display returns to normal
after 3 seconds elapse.
2. Press the ENTER button.
The display changes from flashing to lit.
Sub-woofer with built-in amp
Input terminals
R L
M-CR502N_01_ENG.indd 7 08.8.7 5:28:12 PM