Marantz M-CR502 - Manual (Page 26)

22
NAMES AND FUNCTIONS
BASIC
CONNECTIONS
BASIC
OPERA
TIONS
BASIC
SETTINGS
PRACTICAL
CONNECTIONS
ADV
ANCED OP-
ERA
TIONS
IF YOU EXPERIENCE
PROBLEMS
MISCELLANEOUS
ADV
ANCED OPERA
TIONS
ENGLISH
ADVANCED OPERATIONS
2.
Select a frequency that can be received using
the 1/2 buttons on the unit or the TUNING
3
/4 buttons on the remote controller and
then press the ENTER button.
3.
Select the preset number in which to
register the station using the 1/2 button or
the numeric keys on the remote controller,
and then press the ENTER button.
Note:
Press the ENTER button within 4 seconds after
selecting the preset number. Registration is
canceled if the ENTER button is not pressed within
4 seconds.
CALLING UP REGISTERED BROADCAST
STATIONS
1.
Call up a preset number using the ∞/§
buttons on the unit or remote controller.
• Registered stations can also be called up
using the numeric keys on the remote
controller.
DELETING REGISTERED PRESET NUMBERS
1. Preset numbers can be erased by calling
up the number you want to erase and then
pressing the
7 button on the unit.
2. If you want to erase all preset numbers, be
sure to hold down the 7 button on the unit
for 3 or more seconds.
NAMING REGISTERED BROADCAST
STATIONS
3. 2. 5. 3. 3. 3. 2. 5. 3. 3.
1. Call up the broadcast station you want to
give a name to.
2. Press the MODE button on the unit.
3. Specify the name using alphanumeric
letters (A to Z) and numbers (0 to 9) using
the 1/2 buttons and confirm using the
ENTER button.
• Select the space located between “Z”
and “0” to enter a space.
• Press the 7 button on the unit to erase
the last character entered.
• Hold down the 7 button on the unit for 3
or more seconds to erase all characters.
4.
Repeat Steps
1.
through
3.
about until
you have entered all characters.
5.
Register the name by pressing the MODE
button.
FM RECEPTION MODE
When FM is selected as the tuner band, it may
sometimes be difficult to receive broadcasts in
stereo when the signal is weak. In such cases,
be sure to switch the FM reception mode to
mono. This will help alleviate noise and make the
frequency easier to listen to.
1. 2. 3.
2. 3.
2. 3.
1.
1.
Press the MODE button on the unit for 3 or
more seconds or the SET UP button on the
remote controller.
2. Select “FM STEREO/MONO” from the
menu by pressing the 1/2 buttons on the
unit or the VOLUME buttons on the remote
controller and then press the ENTER
button.
3. Select “MONO” using the 1/2 buttons
on the unit or the VOLUME buttons on
the remote controller and then press the
ENTER button.
• The default setting is STEREO.
Note:
FM reception mode settings can only be made when
the FM band is selected for the tuner.
M-CR502N_01_ENG.indd 22 08.8.7 5:28:41 PM