3 mounting the hydraulic module, Mounting the hydraulic module, 3 – mounting the hydraulic module – Nortec ME Control Installation User Manual

Page 24

Advertising
background image

24 Installation

4.3

Mounting the hydraulic module

The mounting procedure of the hydraulic module depends on whether or not the hydraulic module is

mounted internal or external to the duct.

4.3.1 Mounting the hydraulic module (internal installation)

1. Apply

silicone free grease (e.g. gasket grease) onto the surface of the tank connector and onto the

surface of the rubber sealing inside the connector of the hydraulic module.

2. Then, slide the connector bore of the hydraulic module carefully onto the tank connector until it comes

to a stop.

3.

With the help of a spirit level and the levelling feet on the bracket, align the hydraulic mod-

ule exactly horizontal in both planes, i.e. front to back and left to right. Then, fix the hydraulic

module to the tank using the bracket, nuts (M8, AF: 13 mm) and washers supplied and tighten the

nuts.

Fig. 14: Mounting the hydraulic module (internal installation)

Advertising