Nortec ME Control Installation - Manual (Page 25)

25 Installation
4.3.2 Mounting the hydraulic module (external installation)
Clearances to be observed
Fig. 15: Clearances to be observed when mounting the hydraulic module externally
110
.5 mm
(4.35
")
325 mm
(12.80")
310 mm
(12.20")
11
0 mm
(4.33
")
15
0 mm
(5.91
")
110
.5 mm
(4.35
")
156.83 mm
(6.17")
173.17 mm
(6.82")
127.5 mm
(5.02")
10 mm (0.39
")
8.5 mm
(0.33")
10 mm (0.39
")
MINIMUM 25 mm (0.98")
CLEARANCE TYP. HYDRAULIC MOUNTING
BRACKET
Ø80 mm (3.1.5") HOLE
MINIMUM CLEARANCE OF
300 mm (11.81") REQUIRED
AHU WALL
DETAIL A
DETAIL A
TYPICAL HYDRAULIC
MOUNTING POSITION
WHEN PLANNING THE INSTALLATION OF A ME CONTROL
SYSTEM (WITH EXTERNAL HYDRAULICS) THE CLEARANCE
REQUIRED (OUTSIDE THE AHU) FOR THE FOLLOWING SHOULD
BE CONSIDERED:
• DISTRIBUTION HOSES
• PRESSURE EQUALISATION
• FEED THROUGH PLATES
• INLET ASSEMBLY
• DRAIN PLUMBING
• DRAIN TRAP