D-Link DI-1162 - Manual (Page 124)

DI-1162 Remote Access Router
114 Configuration and Management
Ping Test
This test makes sure there is an IP network connection to a particular
IP address.
♦
IP Address – This is the IP Address of the device that the router
will attempt to reach. The router will check it routing table and try
to locate the IP Address.
♦
Count – The number of pings (packets) that will be sent.
♦
Delay (10ms) – The amount of time in 10 millisecond intervals
between each ping in the Count.
♦
Start Ping Test - Press <Enter> or <Return> to begin the test.
System LAN Test
The System LAN test is used to diagnose the LAN port. It can only be
run if the LAN port is disabled in the Interface Configuration submenu.