D-Link DI-1162 - Manual (Page 96)

DI-1162 Remote Access Router
86 Configuration and Management
Static NAT
This screen (below) is how the NAT IP Pool appears, if Static NAT
was chosen for the Translation Mode parameter. Each entry in this
configuration is used to map a single global IP address a single local IP
address.
The parameters are described as follows:
•
Global IP – this is a single, global IP Address that is valid on the
Internet, or on the same subnet of the global interface.
•
Local IP – this is a single, local IP Address that is not valid on the
Internet.
Static NAPT
This screen (below) is how the NAT IP Pool appears, if Static NAPT
was chosen for the Translation Mode parameter. Each entry in this
configuration can be used to map a global address and port to a local