D-Link DI-1162 - Manual (Page 27)

DI-1162 Remote Access Router
Installation 17
Step 3a - Configuring the LAN Port
Preparing the router for connection to a LAN only requires enabling
the LAN port, enabling IP networking and assigning the LAN port an
IP address. After the LAN port is configured, all other features on the
router can be configured remotely through the LAN by using the
included Windows-based Router Configuration Utility or Telnet.
To configure the LAN:
1. The LAN port must be enabled in the Interface
Configuration sub-menu.
♦
Choose Interface Configuration, LAN 1.
♦
Position the cursor over the State item and press <space bar>.
The State will change from Disable to Enable .
♦
Position the cursor on the Save option at the bottom of the
screen and press <Enter> to save the new setting.