D-Link DI-1162 - Manual (Page 63)

DI-1162 Remote Access Router
Configuration and Management 53
Range – is the number of IP Addresses that can be assigned. In the
window shown above, dial-in users will be assigned the IP
Addresses 170.100.200.1 or 170.100.200.2 (only two are
necessary since the router used in the examples has only two WAN
ports).
WAN 1
This submenu contains a number of settings (shown below) which
allow you to configure the router to dial out.
The parameters are described below:
•
Idle Time – this is the elapsed time (in seconds), of inactivity, that
will trigger the router to disconnect this interface.
•
Dial-Out Retry Time – this is the time (in seconds) the router will
wait before the next dial attempt.
•
Dial-Out Retry Count – this is the specified maximum number of
dial attempts the router will make when trying to establish a
connection on this interface.
•
Dial on Demand – this disables or enables dial on demand on this
interface. If enabled, when a packet arrives at this port, the router