D-Link DI-1162 - Manual (Page 66)

DI-1162 Remote Access Router
56 Configuration and Management
Dynamic - taken from the Dial In IP pool, or
None - the remote user supplies his own IP Address.
State – enables/disables this User Profile.
Remote Network Profile
The Remote Network Profile is used to configure the router for
WAN connections to other networks. In practice, the DI-1162 will
either dial-out to or receive incoming calls from another router, the
‘gateway’ to the other network.
•
Remote Name – Name for the remote network that the DI-1162 is
being set up to connect with.
•
Direction – dial-[In], dial-[Out], or [Both]. This field defines
whether the router on the other network will dial-[In] to the DI-
1162 to establish a connection, the DI-1162 will dial-[Out] to the
other network, or a connection can be established [Both] ways.
When this is set to In, the DI-1162 will only establish a connection
with the other network by receiving calls on the WAN port
specified in the Interface field below. Also, the incoming calls
will be subject to the Name, Password and Rem CLID fields in the
Incoming section below.