Paloma PHH-32 part 2 - Manual (Page 30)

66
Start/Adjust
INSTALLATION INSTRUCTIONS
While “120” is blinking, press the UP and
DOWN adjustment buttons at the same time.
“120” will stop blinking.
Press the UP or DOWN adjustment button to
set the desired temperature.
Turn on the gas and water to the water heater
by opening the shut-off valves.
To limit maximum water temperature setting
to 120°F (49°C):
Turn on the remote control.
Turn off the gas and water to the water heater
by closing the shut-off valves.
Press the DOWN adjustment button repeatedly
until 100°F (38°C) or 85°F (29°C) shows in the
LED display. Hold the DOWN button until the
number on the display starts to blink.
While the number is blinking, press the UP and
DOWN adjustment buttons at the same time.
The number will stop blinking.
Press the UP or DOWN adjustment button to
set the desired temperature.
Turn on the gas and water to the water heater
by opening the shut-off valves.
4
5
6
1
2
3
4
5
6
Setting the Water Temperature (cont.)