QuickLabel CU-30 - Manual (Page 10)

6
Cutting short tags
If you will be cutting and stacking tags that are 1 inch long or less,
the tags will not stop above the cutter-stacker’s belt drive roller and
the tags will not form a neat stack. To allow the short tags to stack
properly, you should install the Short-Tag Adaptor Plate that was
included with your cutter. This plate will correctly position the tags
for stacking.
1 Slip the Adaptor Plate onto the front of the stacking
tray, making sure the bottom of the plate rests over
the edge of the white plastic comb-like guide at the
bottom of the stacking tray.
2 Align the two standoffs on the plate with the
corresponding holes in the stacking tray. Use a
Phillips screwdriver and two screws to fasten the
Adaptor Plate to the stacking tray from the back.
3 Lift the guide roller assembly nearest the stacking
tray and swing it over the front guide roller assembly.
fasten the two screws
into the standoffs in back
swing rear guide roller
assembly over front
assembly