QuickLabel CU-30 - Manual (Page 14)

10
5 Using the 9-pin serial cable provided, connect the
cutter’s serial D-shell interface to the printer’s
UTILITY port.
6 Apply power to the printer.
7 Ensure that the cutter is enabled in the printer's
software:
a) On the printer's keypad, press the MENU
pushbutton.
b) Select the Mode submenu.
c) Use the arrow keys to choose Enabled, then
press SELECT again.
8 Press the Form Feed/Advance pushbutton on the
printer’s keypad.
9 Feed the tag media between the plates of the
media extension bracket on the CU-30 or CS-40.
When feeding media from the printer into the CU-
30 or CS-40, the media should be advanced no
more than an inch or two between the extension
bracket plates. The actions of the printer automati-
cally feed the tag media into the cutter-stacker.
Feed the tag media over the extension plate and
travel roller and beneath the static brush on the
CTS-45.
Ensure that no tag media is under the cutter blade
when power is applied to the cutter-stacker.
10 Apply power to the cutter-stacker.