QuickLabel CU-30 - Manual (Page 7)

3
angle adjustment knob
tray adjustment knob
tray securing screw
stacking tray
tray base
3 Turn the angle adjustment knob clockwise to lower
the stacking tray.
4 Using the two tray adjustment knobs, adjust the
position of the stacking tray for the cut tag length.
The stacking tray should be positioned so that cut,
stacked tags are stopped at least 5 mm (
1 /
8
inch)
above the cutter-stacker’s belt drive roller. The
objective is to allow each tag to pass under the
previous tag to build a neat stack from the bottom up.