Rena T-350 - Manual (Page 11)

ASSEMBLY
Section 2 – Assembly
Stand-Alone Mode
Note: This process assumes you will be using the system as a “stand-alone” tabber.
Follow the steps below to prepare the T-350 for “stand-alone” operation.
1. Remove all the components from the accessory box.
2. Attach the Rear Paper Support using the
two thumbscrews and washers provided.
The finger, on the bottom edge of the Paper
Support, must be inserted into one of the
locator holes, in the frame of the tabber.
The Paper Support is then secured to the
frame with the thumbscrews, as shown.
When double tabbing; set the Paper
Support to the far left locator hole. This
will center the Paper Support on the
tabber.
When single tabbing the Paper Support
can be positioned in any of the other
locator holes. Try to position the Paper
Support so it is center on the media you
are feeding.
3. Install the Paper Support Wedge onto the
Rear Paper Support, using the thumb screw
and washer supplied.
Two Paper Support Wedges are included
with the tabber. The narrow wedge is for
media that is 6.25” wide or less. The
standard (wider) wedge is for all other
media.
T-350 Operations Rev. 3/23/2009 11