Rena T-350 - Manual (Page 7)

GETTING ACQUAINTED
Introduction: The T-350 Tabber is a tabletop tabbing machine that is designed for the
moderate volume user. It can be used “stand-alone” or “in-line” with other devices.
The T-350 Tabber applies Rena FanFold, “tractor-fed” clear, translucent, and paper tab
stocks; which have been engineered to run on the T-350. Tab stock can be purchased
through your local Rena Systems Dealer. See “Appendix B” for tab selection.
Front View
CONTROL PANEL
TAKE-UP SPOOLS
REAR PAPER SUPPORT
MEDIA SIDE GUIDES
PAPER SUPPORT WEDGE
SHEET SEPARATORS
FEED ROLLERS
FEEDER CONTROL
PORT
1. TAKE-UP SPOOLS – Winds up the tab web material (waste).
2. MEDIA SIDE GUIDES – Used to position the media in the tabber and provide
straight feeding of media.
3. FEEDER CONTROL PORT– Can be used to control the start/stop function of
optional external feeders. Feeder must accept “dry contact” input control.
4. PAPER SUPPORT WEDGE – Allows for adjustments in stack angle, based on
media type and length. Helps to force the media against the separation area.
5. REAR PAPER SUPPORT – Provides the proper angle to enhance media
feeding and separation.
6. SHEET SEPARATORS (four) – Used to separate a single piece of media from
the stack.
7. FEED ROLLERS (four) – Delivers the bottom piece of media, from the stack,
through the separation area, and under the forwarding rollers.
8. CONTROL PANEL – Items used to control the operation of the tabber.
T-350 Operations Rev. 3/23/2009 7