Rena T-350 - Manual (Page 28)

OPERATING THE TABBER
Loading Media
When placing media into the tabber, it is important to follow these steps.
1. Start by placing a single mail piece
into the feed section, so that it is
touching or starting to feed under the
sheet separators.
2. Fan the stack of material so the
bottom pieces are closest to the
separation point, as shown. Then
carefully place the stack into the
hopper.
3. Additional pieces can be placed onto
the stack, as described in the above step.
4. If the tabber runs out of material, be sure to reload the tabber beginning with the
first step.
Media Transport Test (Paper Feed)
Take the time to verify proper media transport before trying to tab. If the media
doesn’t feed correctly, it will not be tabbed correctly.
Proper Media Transport:
ƒ One piece of media is fed at a time.
ƒ A gap of at least 1 inch is generated between each piece of media.
ƒ Media is feeding straight.
1. Start by placing one piece of media into the hopper, so it is against or just feeding
under the separators.
2. Place a handful of media on top of the piece already in the hopper.
NOTE: When placing material into the hopper, ensure that it is fanned so the
bottom pieces stick out further than the top pieces. See “Loading Media”.
3. Make sure the Tab button is “off” (not illuminated), and then press the Feed
button to start feeding.
T-350 Operations Rev. 3/23/2009 28