Rena T-350 - Manual (Page 15)

ASSEMBLY
6. Attach the Tab Box Tray.
The hooks on the
Tab Box Tray fit
over the upper shaft,
at the exit end of the
tabber, as shown.
The tray hangs off the exit end of the
tabber.
7. Proceed to “External Feeder Control Setup”.
In-Line Roller Assembly Removal
If you ever need to remove In-Line Roller Assembly, a small
screw driver can be inserted under the spring wire, through
the smaller hole in the sidewall. Push up lightly on the spring
wire, to release the pointed end of the shaft; allowing the
pointed end of the shaft to be pulled out of the side-wall.
The flat end of the shaft can be removed from the sidewall,
without releasing the spring wire tension.
T-350 Operations Rev. 3/23/2009 15