Rena T-350 - Manual (Page 17)

ASSEMBLY
Connecting the T-350 to an External Feeder
Using the appropriate interface cable, attach the external feeder’s interface port to
the T-350’s FEEDER interface port.
ƒ T-350 to RENA EasyFeed 120 feeder: Use Cable Part#: 33E-500-192
Note: Cable 33E-500-192 was made for the T-950, but it will work with T-350 as
well. Set the switch, on the bottom of the EasyFeed 120, to “N.O.”.
WARNING
IF AN INNAPPROPRIATE CABLE CONNECTION IS MADE, DAMAGE
TO THE TABBER AND OR FEEDER MAY OCCUR.
If you don’t have the appropriate cable or don’t know if your feeder is
compatible; please contact your local Rena Systems Dealer for technical help.
The T-350’s feeder interface port provides the following dry contact outputs.
Maximum current capacity = 10 mA
Pin 1: Common
Pin 2: Normally Closed
Pin 3: Normally Open
1
3 2 Pin 4: No Connection
Riser Stand:
When using an external feeder, an appropriate riser stand must be used under the
feeder; to place the feeder output at the appropriate input height for the tabber.
ƒ T-350 to RENA EasyFeed 120 feeder. Use Riser Stand Part #: RS-100.
Choosing a Location
ƒ The tabber should be placed on a flat, stable work surface that can properly
support the weight of the tabber and any peripheral equipment (feeder, conveyor,
media, tabs, etc…).
ƒ The tabber should be located in an area that is away from windows or heat
sources. Sunlight will deteriorate the rubber and plastic components on the tabber,
and can cause problem with the function of the media sensor.
Note: Strong over-head interior lighting can also cause problems with the function
of the media sensor.
ƒ An electrical outlet must be located near the unit. The power cord should be
routed in a way that it does not cross an access corridor.
T-350 Operations Rev. 3/23/2009 17