Document Outline

• CONTENT
• 1. Brief Introduction
  • Chapter Structure
  • How to Use the Manual
  • Term and Definitions
  • System Overview
  • Application Questions
• 2. Hardware Orientation
  • In This Chapter
  • VSP 5360 Back Panel
    • CONT Interface
      • 1. Dial Switch
      • 2. 10/100M UDP Interface
      • 3. USB Interface
      • 4. RS232 Interface
    • INPUT Interface
      • 16.17：VGA Input
      • 18.19：Displayport Input
      • 20.21.22：DVI Input
      • 23：3G-SDI Input
      • 24：SDI Loop Out
    • OUTPUT Interface
      • 25.26：DVI Output
      • 27.28：VGA Output
    • Sending Card Interface
      • 5.6.9.10: 10/100M Interface RJ45
      • 7.11：USB Control Port of Sending Card
      • 8.12: DVI Input Port of Sending Card
    • Optional Module
    • 31: S. V. D. U Optional Module
    • Switch and Power
      • 29.30：Power Interface and Switch
  • VSP 5360 Front Panel
    • OLED Panel
    • Menu Buttons
    • Signal Keys
    • Function Keys
• 3. Hardware Installation
  • In This Chapter
  • Safety Precautions
  • Unpacking and Inspection
  • Site Preparation
• 4. Menu Orientation
  • In This Chapter
  • MENU
    • OUTPUT FORMAT
    • SCREEN PARAMETERS
    • SPLIT
    • INPUT SETUP
    • AUDIO SETUP
    • SYSTEM
    • LANGUAGE 语言
    • FACTORY RESET
• 5. Communication Software Guideline
  • In This Chapter
  • Software Installation
  • Softwar e Operation
    • Connection
    • Basic Operation
      • Image Toolbar
      • Preview Screen
      • Program Screen
      • Basic
      • Layer
      • Image 1
      • Image 2
      • Image 3
      • Image 4
      • Save
      • Load
      • Split Joint
    • Tools
      • Logo Capture
      • Output Adjust
      • SDI
      • DSK
      • EDID
      • Audio
      • Option Input
    • Control
      • Device Update
    • Language
      • Admin
      • Help
    • Refresh
      • Information Toolbar
  • How to Connect Windows Control Program by LAN Interface
  • How to Connect Windows Control Program by RS232 Interface
  • How to Connect Windows Control Program by USB Interface
• 6. System Setup and Operations
  • In This Chapter
  • Interface and Input Signal Option
  • How to Realize Single Image Switching
  • How to Do Customized Output Resolution
  • How to Add or Clear the Layer
  • How to Set the Size and Position of the Image
  • How to Crop the Image
  • How to Zoom the Image
  • How to Adjust the Bright and Color of the Image
  • How to Realize the LOGO Capture
  • How to Use Black Out
  • How to Realize the Screen Size Setting
  • How to Realize DSK Setting
  • How to Save the Parameter
  • How to Load the Saved Parameter
• 7. Common Questions and Solutions
  • In This Chapter
  • No Output in LED Display
    • Confirm If There is Any Input Signal
    • Confirm If Signal Output
  • Flash Point in LED Display Output
    • Confirm If Monitor Output is Normal
  • LED Display Only Displays Part of the Image
    • Signal Needs to Scale
  • No Display in the Second Half Part of LED Display
    • Resolution is Insufficient
  • All Key Lights Light on Simultaneously
    • Check If Dial Switch is Normal
• A. Specification
• B. Contact Information
• C. Software Upgrade
• D. Optional Module Installation and
• Replacement Instruction