Desa CD36TN-M - Manual (Page 20)

www.desatech.com 118531-01A 0
6. While supporting speed control, secure control
shaft with lock nut by pushing and turning
lock nut with pliers clockwise until it is tight
against front panel. Place control knob pro-
vided on shaft.
7. Turn on power to duplex outlet if previously
turned off per the warningon page 19.
8. Plug in blower power cord.
a. If your firebox is installed as a free-
standing unit with an accessory mantel,
determine whether the power cord will exit
the left side or the right side of the firebox.
Route power cord through exit hole and
plug the power cord into a wall receptacle
near the firebox.
b. If your firebox installation is recessed
and/or prewired, plug the power cord into
the duplex outlet provided. Refer to your
firebox owner’s manual for instructions
on wiring the duplex outlet.
CAUTION: Never touch the
blower wheel while in operation.
9. Check to make sure that the power cord is com-
pletely clear of the blower wheel and that there
are no other foreign objects in blower wheel.
Turn blower on and check for operation. Turn
blower off by turning knob fully counterclock-
wise before continuing.
10. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the firebox bot-
tom approximately 12" in front of the blower
(see Figure 29).
Var iabl e Fan Sw itch
W hite
W hite
Bla ck
Gr een On
110 /11 5 V.A .C.
Blo we r Mo tor
Bla ck
Bla ck Bla ck
Of f
Figure 29 - Location of Wiring Diagram
Decal (Model May Vary From Illustration)
Wiring Diagram Decal
" in Front of Blower
FIREPLACE
INSTALLATION
Continued
Model BKT Installation
Note:
When installing the BKT thermostati-
cally-controlled blower, you must first secure the
thermal switch bracket to the blower if it has not
already been factory installed.
1. Place the green ground wire with ring terminal
between the bottom hole on the thermal switch
bracket and the top ear hole on the blower as-
sembly. Insert the phillips screw into all three
pieces and tighten securely (see Figure 30).
2. Connect wire harness and power cord ter-
minals. Connect the blue jumper wire to the
blower motor terminal and the right side ter-
minal of the thermal switch. Connect the black
wire to the left side of the thermal switch and
the white wire to the other remaining blower
motor terminal.
Note: The power cord outer insulation sleeve may
have to be stripped slightly to allow enough wire
length to reach and make all connections. DO NOT
trim excessive length away. Just enable enough to
make all connections securely.
Thermodisc
Figure 30 - Blower Model BKT
Air Flow
Direction
Route BKT Blower
Through This Area
Magnets
Blower
Location
Side View Firebox Bottom
Black
Wire
Phillips
Screw
Blue Wire
Ring Terminal on
Green Wire
White Wire
Thermal
Switch
Thermal
Switch
Bracket
Power Cord
Air Flow
Direction
Magnetic
Strips