Teac DR-100MKII - Manual (Page 22)

22
TASCAM DR-100MKII
3 – Preparation for Use
Do not carry or store the battery with small metal •
objects. Doing so could short the battery and cause
leakage or rupture, for example.
When storing or disposing of the battery, cover the
•
contacts with tape to prevent them from touching other
batteries or metal objects.
Follow the disposal instructions written on the battery
•
or provided by the local government when you are
done using it.
Using the remote control
(TASCAM RC-10)
Wireless use
Point the remote control at the remote control receiver on
the unit.
Remote sensor
Operation distance: 7m max.
NOTE
The operation distance varies depending on the angle. •
If anything is between the remote control and the •
sensor, operation might not work.
Wired use
Attach the wired remote control adapter and cable.
1 Insert the wireless remote control into the wired
remote control adapter.
Wired remote
control adapter
2 Connect the cable to the wired remote control
adapter.
3 Connect the cable to the REMOTE/DIGITAL IN jack on
the right side of the recorder.
Enable wired remote control use
On the
REMOTE/DIGI IN
setting screen, enable use of the
wired remote control.
1 Press the MENU button to open the
MENU
screen.
2 Use the wheel to select
REMOTE/DIGI IN
and press
the ENTER/MARK button to open the
REMOTE/DIGI
IN
setting screen.
3 Use the wheel to select
FUNCTION
, and press the
ENTER/MARK or / button.
4 Use the wheel to set
FUNCTION
to
RC-10
(default
value:
RC-10
).
5 After completing the setting, press the HOME button
to return to the Home Screen.
Precautions for use of the remote control
Remove the battery when you are not using the remote •
control for a long time (one month or more).
If the battery should leak, thoroughly clean any residue
•
from inside the battery compartment and install a new
battery.
When using other devices controlled by infrared rays,
•
use of this remote control might operate these devices
by mistake.
Using a cable other than the one included could
•
damage the remote control and the unit being
controlled.
The wired remote control will only function if
• FUNCTION
is set to
RC-10
on the
REMOTE/DIGI IN
screen. (See
“Enable wired remote control use” above.)