Teac DR-100MKII - Manual (Page 57)

TASCAM DR-100MKII
57
12 – Specifications
Ratings
Recording media
SD cards (64 MB–2 GB) and SDHC cards (4 GB–32 GB)
Recording/playback format
WAV: 44.1/48/96 (HS mode) kHz, 16/24-bit
MP3: 44.1/48 kHz, 32/64/96/128/192/256/320 kbps
Number of channels
2 channels (stereo)
Input/output ratings
Analog audio input/output ratings
XLR (MIC/LINE 1) IN connectors (Phantom power
compatible)
Connectors: XLR-3-31 (1: GND, 2: HOT, 3: COLD)
When MIC/LINE 1 switch is set to MIC
Input impedance: 2.1 kΩ
When GAIN HIGH •
Nominal input level: –70 dBu
Maximum input level: –54 dBu
When GAIN MID
•
Nominal input level: –42 dBu
Maximum input level: –26 dBu
When GAIN LOW
•
Nomial input level: –14 dBu
Maximum input level: +2 dBu
When MIC/LINE 1 switch is set to LINE 1
Input impedance: 2.5 kΩ
Nominal input level: +4 dBu
Maximum input level: +24 dBu
LINE 2 IN jack
Connector: 1/8” (3.5 mm) stereo mini jack
Input impedance: 22 kΩ or more
Nominal input level: –10 dBV
Maximum input level: +6 dBV
LINE OUT jack
Connector: 1/8” (3.5 mm) stereo mini jack
Output impedance: 200Ω
XLR LINE 1 IN:
Nominal output level: –14 dBV
Maximum output level: +6 dBV
Others:
Nominal output level: –10 dBV
Maximum output level: +6 dBV
jack
Connector: 1/8” (3.5 mm) stereo mini jack
Maximum output : 25 mW + 25 mW
(with 32Ω headphone connection)
Built-in speaker
Output: 0.4 W (mono)
Digital audio input ratings
DIGITAL IN jack
Connector: 3/32” (2.5 mm) TRS jack (using the conversion
cable made for this unit)
Format: IEC60958-3 (S/PDIF)
Control input/output ratings
USB port
Connector: Mini-B type
Format: USB 2.0 HIGH SPEED mass storage class
REMOTE jack
Connector: 3/32” (2.5 mm) TRS jack
Audio performance
Frequency response
20 Hz–20 kHz, +1/–3 dB
(EXT IN to LINE OUT, Fs 44.1 kHz, JEITA)
20 Hz–22 kHz, +1/–3 dB
(EXT IN to LINE OUT, Fs 48 kHz, JEITA)
20 Hz–40 kHz, +1/–3 dB
(EXT IN to LINE OUT, Fs 96 kHz, JEITA)
Distortion
Less than 0.01%
(XLR LINE 1 IN to LINE OUT, Fs 44.1 kHz, +24 dBu input,
JEITA)
S/N ratio
92 dB or more
(XLR LINE 1 IN TO LINE OUT, Fs 44.1 kHz, +24 dBu input,
JEITA)
Note) JEITA: Conforming to JEITA CP-2150
Requirements for connected
computers
Check the TASCAM website (http://tascam.com/)
for information about the latest operating system
compatibility.
Windows
Pentium 300 MHz or better
128 MB or more memory
USB port (USB 2.0)
Macintosh
266 MHz Power PC, iMac, G3, G4 or better
64MB or more memory
USB port (USB 2.0 recommended)