Teac DR-100MKII - Manual (Page 55)

TASCAM DR-100MKII
55
10 – Messages
Message Meaning and response
No PB File
There is no file that can be played back. The file might be damaged.
No MUSIC File
There is no playback file, so DIVIDE and OVERDUB cannot be executed.
Sample Rate 96kHz
96 kHz WAV files cannot be overdubbed.
DIN Selected
When the REMOTE/DIGITAL IN jack is selected as the input, you cannot change to an analog
input even if you change that INPUT switch on the top panel.
DIN Unlock
The REMOTE/DIGITAL IN jack is selected as the input, but the digital input connection has
been broken or the sampling frequency does not match. Confirm that the external digital
audio equipment is properly connected to the REMOTE/DIGITAL IN jack. Confirm also that the
sampling frequencies of this recorder and the external digital audio equipment are matched.
Press the STOP [8] button to close this message. When this error occurs, the input from the
REMOTE/DIGITAL IN jack cannot be used, but recording is possible. If this message appears
during recording, noise might occur in the recording
Not Continued
If one of these errors occurs, turn the unit’s power OFF and then ON again.
If you are unable to turn the power OFF, remove the batteries and disconnect any TASCAM PS-
P520AC adaptor (sold separately) or TASCAM BP-6AA external battery pack (sold separately)
being used.
If the error message continues to appear frequently, please contact the dealer where the product
was purchased from or the TASCAM Distributor in your area.
File Error
Can't Save Data
Player Error
Device Error
Writing Failed
Sys Rom Err
Remote Cmd
Remote Rx
System Err 50
System Error 1
System Error 2
System Error 3
System Error 4
System Error 5
System Error 6
System Error 7
System Error 8
System Error 9