Thinklogical ImageEvolution X3 Manual - Manual (Page 10)

Revision D 10 June 2011
4. Installation
Image Evolution Setup:
1. In the case of a single link SDI or HD-SDI, or dual link HD-SDI source, coax
cable(s) may be connected between the Image Evolution’s Link1 IN (or in the case of
dual link, Link1 and Link2 IN), and an HD-SDI source. If desired, coax cables may
be connected between the Link1 (or Link1 and Link2) LOOP BACK BNC connectors
and a suitable monitor (or monitors). Loop back outputs will provide a raw or
unprocessed output of the video input on LINK1 IN or LINK2 IN.
2. If single or dual link HD-SDI is the desired output, connect coax cables between
the BNC connector(s) LINK1 OUT (or LINK1and LINK2 OUT) and a suitable monitor
(or monitors). LINK1 OUT and LINK2 OUT provide processed output of the video
input.
3. Connect CAT-5 cable between the RJ-45 on the Image Evolution and 10/100
Ethernet port if a network is available. (Available in future firmware updates)
4. The USB on the Image Evolution need not be connected at this point. Note:
When performing a firmware upgrade it is recommended that the IEX3 be restored