Thinklogical ImageEvolution X3 Manual - Manual (Page 22)

Revision D 22 June 2011
MAIN MENU:
A:
Set Input Select
Note : A valid input must be applied in order for the configuration to be used.
a: Single Link Input 1
Selects the video and embedded audio source from BNC Input 1. This will select
the video signal to be processed from link 1. Note: This is also the default link
and does not have to be selected when configuring the output video format.
Signal does need to be present for configuration to be successful.
b: Single Link Input 2
Selects the video and embedded audio source from BNC Input 2.
c:
Dual Link
Selects a Dual link Video and embedded audio source on BNC Inputs 1 and 2.
d:
Dual Stream 3D
Inputs 1 & 2 are to be used for Left Eye / Right Eye signals for 3D processing for
output line-by-line, side-by-side, or rate-converted Dual Stream.
e:
Enable Loop 1 Output
This will enable the video signal applied to input 1 to be looped back out of the
IEX3. This is enabled as default.
f: Disable Loop 1 Output
Turns off the BNC Loop output 1.
g:
Enable Loop 2 Output
This will enable the video signal applied to input 2 to be looped back out of the
IEX3. This is enabled as default.
h: Disable Loop 2 Output
Turns off the BNC Loop output 2.
i:
AUTO mode ON
Detects when a video source has changed format. On cable insertion, the unit
performs a re-configuration of the last known output setting with the new input.
j: AUTO Mode OFF
Turns off the AUTO mode.
j:
Right Half Frame (3D to 2D)
This feature will scale the right half side of the input video and display it as full
screen.