Thinklogical ImageEvolution X3 Manual - Manual (Page 8)

Revision D 8 June 2011
2.2. Hardware
2.2.1. Desktop or Rack Mount Device
You may choose to place it on a shelf or desktop (rubber feet included), or rack mount using
the supplied mounting brackets (19 inch rack mountable). The front panel should be visible
and unobstructed to facilitate programming. The front panel buttons may also need to be
accessible. All connections are made to the rear of the chassis. The ImageEvolution X3
chassis does not need to be opened or accessed. The sturdy metal case allows units to be
stacked, as required.
2.2.2. Cooling
The ImageEvolution X3 uses two DC fans to move air horizontally through the enclosure.
They will turn on automatically when the internal temperature reaches a preprogrammed
temperature.
Note: Be sure to leave adequate ventilation space on both sides of the units
(2” minimum), especially if the units are being stacked.
3. Connecting the ImageEvolution X3
All physical connections to the product use industry-standard connectors. All
connections are found on the rear of the unit.
3.1 Front Panel View:
3.2 Rear Panel View