Verilink PRISM 4101 (34-00230) Product Manual - Manual (Page 48)

36 C HAPTER 4: T ERMINAL I NTERFACE
must press Return on one of the fields or exit the screen. The underlined values are
the factory default parameters.
Changing any of the line or DTE settings briefly interrupts end-to-end traffic as the
new setting is put into effect. Choosing an incorrect or invalid setting may disrupt
end-to-end traffic until a proper setting is established.
Figure 4-7 Configuration Menus Structure
DDS Network Parameters
The DDS Network Parameters screen (Figure 4-8) allows you to review and set
line parameters for the selected element on the DDS circuit.
Figure 4-8 DDS Network Parameters Screen
Rate. Selects the network interface line rate. The unit must be manually set to a
specific line rate. The rate choices are 2.4, 4.8, 9.6, 19.2, 38.4, 56 and 64 kbps.
Data Mode. When set to TxPORT, the unit operates in the proprietary mode where
TxPORT specific equipment must be located on both ends. When set to
STANDARD, the unit operates in an industry standard mode allowing it to
interoperate with equipment from another vendor.
DTE Port
Parameters
(page 37)
Alarm
Parameters
(page 41)
TCP/IP
Parameters
(page 42)
DDS Network
Parameters
(page 36)
Configuration Menu
Management
Ports
(page 45)
Summary
(page 49)
SNMP
Parameters
(page 43)
Dial Backup
Parameters
(page 46)